Hi all
I wanted to report on some success I have had treating pimples.
I have never had major issues with acne, but on occasion I do get pimples on my face. They usually start as an inflamed raised area on my forehead that is visible, and can be felt. Applying pressure to the area produces pain, and I usually discover these in their early stage when washing my face. These raised patches usually erupt into pimples that take a few days to heal.
What I did was apply contact mode using this probe directly over the raised bump:
SMD Inductor Test Meter Clip Probe
SMD Inductor Test Meter Clip Probe.jpg (19.61 KiB) Viewed 281 times
I used the following settings:
Dwell: .02
Amplitude: 4 (any higher stings)
Amplitude Ramp: Off because the dwell is so short
Reduce Amplitude: Off
Offset: 100 & -100
Apply Freq: Direct
Wave: Square with Inverse+Sync
Frequency Set: Acne 1 (CAFL)
I connected the probe with the contact crocodile clips to the CS output on my Boost.
The whole program runs for about 1 minute and 20 seconds. I apply the probes to the pimple for maybe 1 or 2 rounds.
I have done this about four times now over the past few months, and every time has been a success. On my last attempt the pain disappeared in about an hour, and a small pimple appeared a few hours later. I popped it and by the morning there was no trace of the pimple or any inflammation at all.
Warning: Contact mode is not advised above the shoulders, but I decided to ignore this warning because the distance between the probe pins is so small.
Thanks to the Spooky team!
Source: http://www.spooky2.com/forums/viewtopic.php?f=20&t=4473
buying 10set.
Hi, Could you tell me exactly what you mean? You could buy Spooky2 products from this website.https://www.spooky2-mall.com/ If you have any questions, you can always contact us and we will help you!