Hello,
have been using three Spooky2 generators for 3 weeks for family and myself. Everything is very positive.
Just destroyed a Stye that had formed on the inside of the lower eyelid. Previous, similar styes have persisted for decades.
After using the generator for 1.5 hours the hard stye had a dimple in the middle and after another 1.5 hours, the next day, it simply popped right out when poking it with a pin. Remarkable success.
The settings were:
stye (CAFL) Note: after entering this setting four other recommendations appear… these are for Staphylococci and Streptococcus.. I used all of them.
Freq. Mult. 1 Duty Cycle 50 50 Fibonacci 11 stage wobble
Repeat 1 Amplitude 20 20
Repeat 1 Offset 0 0 No not sort frequencies
Repeat 0 Phase Angle 0 0
Dwell Amp 1
Having a problem adding 3 more generators for a total of six. Once all set up they all worked fine for 2.5 hours then stopped working. This problem persists where they will work for a few hours and then stop. Once stopped they all show that they are on but the frequencies no longer change and the remotes sing at the last frequency the were on. None of the generators are running hot. It seems to be from the software or cable perhaps?
Perhaps this is too much data for the cable to handle? I also have issues where the data downloads in packets (?) where the frequency changes are slow as is the seconds timer.
I have tried going back to just one generator but it also stops working after a few hours. Restarting the pc and reloading the generators does not seem to help.
I can still use a single generator by itself in contact mode but in remote even one generator just does not stay on more than a few hours.
The repeat setting is set at ‘0’.
Thanks to John White and all others who have made this wonderful technology available.
Source: http://www.spooky2.com/forums/viewtopic.php?f=20&t=3152
